Connections, Control And Adjustment Elements - B.A. International UltraSeal BASE750 Manual Del Usuario

• The sealer must only be connected with the supplied power cord to a grounded socket... It is not allowed
to be connected to an IT power supply...
• Put the device on a stable surface...
• If the sealer is transported from a cold into a warm environment, it is possible that there will be some
condensation... Wait until the temperature is equalised... There is danger for loss of life, if the device is put
into operation when there is any condensation!
• Only authorised staff is allowed to exchange fuses and carrying out repairs... Please contact your local
distributor or BA International...
• Before cleaning: Disconnect power from the mains! Clean the sealer only with a dry or slightly moistened
smooth wipe... Never let water come into the sealer...
• Only use the sealer in dry rooms at ambient temperatures between 15 and 30°C... If the sealer is used
under conditions out of this specification, functional errors could occur or the sealer could be damaged.
Let the sealer come to room temperature before taking it into operation...
• Only seal suitable packaging material... If in doubt contact your dealer or the manufacturer of the sealer...
• Never seal polyethylene pouches or similar... This will damage your sealer...
• Never insert pointed or flat instruments into the in feed gap. This could damage the sealer or the instru-
ments...
• Never insert parts into the ventilation gaps of the sealer... You could be injured by an electric shock or the
sealer could be damaged...
• Check electrical safety of the sealer at least every year...
• Never use the sealer if there is any doubt if it is in a safe condition...
• The user is responsible for a acceptable sealing result... Let the seam be checked frequently... Let the seal-
ing process be validated...

2 Connections, control and adjustment elements

Height adjustment
Motor fuse
Power switch
Power entry
Main fuse
Paper guide
3
Motor switch
Operating panel