Publicidad
Idiomas disponibles
Idiomas disponibles
LY
TO ASSEMBLE
AND ATTACH
GRASS
CATCHER
(See Figs. 3A thru 4)
-
insert leg of tubular frame through front opening of
grass catcher and thread frame into sewn hem of bag.
NOTE: Keep bag hem gathered on the straight leg of the
tubular frame.
•
When frame comes out the other end of sewn hem,
immediately work the end of frame down inside the bag
as shown in inset°
=
Slide sewn hem evenly around the tubular frame until
both ends of frame are exposed out of the front open-
ing.
.
Assemble lower frame to tubular frame as shown. Be
sure handle is outside of bag and frames are fully
seated as shown in inset.
-
Slip vinyl bindings over frame.
NOTE:
If vinyl bindings are too stiff, hold them in warm
water for a few minutes. If bag gets wet, let it dry before
using.
•
Close the flip lid, Flip lidmust be ctosed while operating
lawn mower°
.
Lift the rear door on the mower housing and place the
grass catcher frame onto the formed tabs on the rear
door hinge brackeL
.
The grass catcher is secured to the lawn mower
housing when the rear door is lowered onto the grass
catcher frame,
..................
i,i
,i
i
ilJl
iiillll
iii
CAUTION: Do not run your lawn mower
m
without clipping deflector or approved
i
grass catcher in place. Never attempt
to operatethe lawn mower with the rear
door removed or propped open.
TUBULAR FRAME
SEWN
SEWN HEM
FLIP LID
\
FIG. 3C
DOOR
BRACKET
GRASS
CATCHER
FRAME
FORMED
TABS
FIG. 4
FIG. 3A
7
Publicidad
