Publicidad
Idiomas disponibles
Idiomas disponibles
Assembling the appliance
Remove any remaining packaging from the device and assemble the component parts:
1.
If necessary, mount the dust container (see also chapter "Cleaning the dust container"), insert the filter and mount the
filter cover.
2.
Push the suction tube onto the device.
3.
Depending on the application, attach the floor nozzle / upholstery nozzle / 2in1 tool / crevice nozzle to the suction tube.
It is best to charge the rechargeable battery before each use, especially after the appliance has not been used for a while.
This increases the service life of the rechargeable battery and ensures the longest possible cleaning cycles.
1. Insert the plug of the power supply unit supplied into the connection socket of the appliance.
2.
Connect the mains adapter included in the delivery to a socket.
- The dots in the display on the handle start flashing. The more dots flash, the further the charging process has
progressed.
- As soon as the battery is fully charged, all dots light up for a few minutes and then go out. The charging process takes
approx. 5 hours when the battery is empty.
3.
Disconnect the mains adapter from the socket.
4.
Pull the plug of the power supply unit out of the connection socket of the appliance.
The operating time with a fully charged rechargeable battery is approximately 18 minutes (in Power mode) or 40
minutes (in Eco mode).
TIP: If the appliance is used infrequently, the power supply should not remain permanently connected.
Selecting floor nozzle, turbo upholstery nozzle, 2in1 tool or crevice nozzle
Floor nozzle
Turbo upholstery nozzle : for upholstered furniture and cushions
2-in-1 tool
Crevice nozzle
∙ Select the desired attachment and place it on the mounted appliance.
∙ Adjust the telescopic tube to the desired length.
∙ All attachments can also be used without the suction tube, e.g. to vacuum furniture. Make sure that the substrate can
withstand the stress of the brush roller without damage.
Vacuuming in Eco mode
In power mode, the hand vacuum has a higher output. The brush roller rotates.
1.
Attach the floor nozzle to the suction tube.
2.
Press the switch on the handle of the appliance to switch on the appliance. Eco mode is activated.
3.
Vacuum the floor.
4.
Press the switch again to switch off the appliance.
5.
Empty and clean the dust container (see chapter "Maintaining the appliance").
Vacuuming in Power mode
In Power mode the hand-held vacuum cleaner operates with higher power and the brush roller rotates.
1.
Attach the floor nozzle to the suction tube.
2.
Press the switch on the handle of the appliance to switch on the appliance. Press the rear button on the top of the
handle once. Power mode is activated, MAX lights up in the display.
3.
Vacuum the floor.
4.
Press the switch again to switch off the appliance.
16
Charging the rechargeable battery
Operating the appliance
: for hard floors and carpets
: for vacuuming e.g. furniture.
The brush attachment can be pushed back, e.g. to suck up crumbs. To do this, press the
locking button on the brush and push it forwards or backwards.
: for vacuuming hard-to-reach corners
Publicidad
