HOW TO REMOVE THE CHUTE
1. Remove the fasteners that secure
the chute to the top cover.
2. Remove the chute.
Chute
Top
Cover
Figure 24
HOW TO ADJUST THE BRAKE PAD
IMPORTANT:
An adjustment
is only
necessary
if the brake
pad has become
loose or has been removed.
To adjust,
proceed
as follows:
1. Remove the top cover. See "How To
Remove The Top Cover".
2.
Remove
the belt cover. See "How
To Remove
The Belt Cover".
Brake
Pad
Drive
Belt
3. Tie the auger drive lever to the han-
dle. This will engage the drive sys-
tem.
4. Loosen the screw and nut on the
brake pad arm (Figure 25).
5. Set the clearance between the
brake pad and the drive belt to 1/8
inch.
6. Tighten the screw and nut on the
brake pad arm.
:::
Belt Guide
Brake Roller
Figure 25
F 041032C
21