Running The Software; Starting The Driver Of The Interactive Whiteboard - Olivetti OLIBOARD-80T Manual Del Usuario

R S
UNNING THE OFTWARE
The whiteboard cable must be connected to the USB port of the computer.
To run the software, first of all the software driver of the whiteboard must be started,
the orientation operation performed if necessary, after which the whiteboard
software can be started.

Starting the Driver of the Interactive Whiteboard

Click "Start"  "All programs"  "Oliboard Software " and start the Oliboard
Driver. The driver icon
the desktop.
NOTE: If the message "Start device failed",make sure that the cable of the
whiteboard is connected correctly between the computer and the
whiteboard.
NOTE: After having started the driver, click on the icon of the Oliboard driver
to activate or deactivate the autostart parameter, depending on whether or
not you want the Oliboard driver to be run automatically the next time the
computer is powered on. If the computer is permanently connected to the
whiteboard, it is advisable to activate the autostart. On the other hand, if the
computer could be disconnected from the whiteboard, it is advisable to
deactivate the autostart to avoid an error message appearing the next time
the computer is powered on which indicates that no whiteboard is
connected.
OLIBOARD - Interactive Whiteboards
appears in the lower right corner of the Status bar on
7