7.Warning
Before using this device, please read this guide which contains important
operating instructions for safe usage, control information and operational
instructions for compliance with RF Energy Exposure limits in applicable national
and international standards.
FCC
This device complies with part 15 of the FCC Rules for use with cable television service.
Operation is subject to the following two conditions: (Other devices are applicable)
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
13
CE
•(Simple EU declaration of conformity) Hong Kong Svbony Technology Co.,Ltd. declares
that the radio equipment type is in compliance with the essential requirements and other
relevant provisions of EMC Directive 2014/30/EU and the ROHS Directive 2011/65/EU and
the WEEE Directive 2012/19/EU; the full text of the EU declaration of conformity is available
at the following internet address: www.svbony.com.
Disposal
The crossed-out wheeled-bin symbol on your product, literature, or
packaging reminds you that all electrical and electronic products,
batteries, or accumulators must be taken to designated collection
locations at the end of their working life. Do not dispose of these
products as unsorted municipal waste. Dispose of them according to
the laws and rules in your area.Iug
IC Requirements:
CAN ICES-3(B)/NMB-3(B)
Authorized Accessories
•This device meets the regulatory standards when used with the Svbony accessories
supplied or designated for the product.
•For a list of SVBONY-approved accessories for your radio model, visit the website http://w-
ww.Svbony.comv
14