Mark SET MAP 1500 Manual Del Usuario página 4

Idiomas disponibles

CONTROLS & FUNCTIONS

1. DSP modes LED Indicator: These LEDs are used to indicate the DSP operation modes (NORMAL,

DJ, VOICE, LIVE, FLAT)

2. OPERATION LEDs: These LEDs indicates POWER, SIGNAL and CLIP.

3. DSP: Press this knob to change DSP modes.

4. RCA IN: This RCA plug input is used to plug a cable to get signal from CD player or other devices.

5. LINE A: This combi plug is used to plug XLR/TRS Line level signal.

6. LINE A VOL: This knob is used to increase/decrease the volume output of LINE A.

7. MIX OUT: This XLR plug provides a mixed LINE output from A and B inputs.

8. MIC/LINE switch: Press it down to use the channel as MIC input. Press it up to use the channel as LINE

input.

LINE B VOL: This knob is used to increase/decrease the volume output of MIC/LINE B.

9. MIC/

10. MIC/LINE B: This combi plug is used to plug XLR/TRS Mic/Line level signal.

11. SATELLITE OUT: This Speakon XLN plug is uset to connect output to satellites.

FUSE: The FUSE compartment contains the equipment's power protection fuse, remove it for

12.

replacement if necessary.

AC LINE INPUT: This PowerCon NAC3 plug is used to provide power supply.

13.

POWER: Switches on ( I ), off ( O ) the system.

14.

VOLTAGE SELECTOR: Switches between 110-220V main power supply.

15.