INSTALLATION INSTRUCTIONS
= Level adjustment
i i
_iiiii_i
_
i?
_
/_igher
Adjustable feet
Adjustable feet
hi"
• Leveling
the washing machine
properly
prevents
excessive
noise and vibration,
Install the appliance
on a solid and level floor surface,
preferably
in a corner of the room
• If the floor is uneven, adjust the adjustable
feet as
required
(Do not insert pieces
of wood, etc., under the
feet )
NOTE:
Exfend
the feel no more than necessary
to level
the washer.
The more the feel are exleoded,
the
more the washer
will vibrale_
* Make sure that all four feet are stable and resting on
the floor and then check that the appliance is perfectly
levet (Use a level)
• After the washer is level, tighten the lock nuts up
against of the base of the washer Al! lock nuts must
be tightened
, tt is critical to adjust the feet pedectly This must be
done while the washer is spinning with a load Use the
wrench (supplied) to adjust the feet until there is no
vibration, Then tighten the lock nuts to prevent further
adjustment.,
NOTE: If there are vibration andnoise (luring the spin
cycle, re-check the leveling of the washer, adjust
the [eel as required, anti tighten the lock nuts
securely to prevent changes in adjustment,
Run the washer with a lesl load to make certain
your washer is properly leveled,, Put
approximately
6 poamts of tanmlrLy in the
machine. Then, press POWER. RINSE+SPIN, and
START!PAUSE, in tha! order. When Ihe machine
spins al high speed, verify that it is slable° If nnl,
adjust tile feel accordingly.
* Diagonal
Check
When pushing do_lw the edges of lhe washing
machine
top plate diagonally,
the machine
should nol move up
and down at all. (Please, check both directions.)
If lhe machine rocks n,hcn pushlog
the machine
top plate
diagonal(€,
adjust the feet agaia,