Publicidad
1.0
CONTROL PANEL
SE E T T
SET
One touch key
TO DISPLAY OR CHANGE THE SET POINT
1. Press and release the SET key: the set point will immediately be displayed
SET
SE E T
2. The SET LED will blink
3. To change the value, use the and keys.
4. To save the new set point, press the SET key or wait 15 s to exit from
programming
TO START A MANUAL DEFROST CYCLE
1. Press the DEF key for more than 2 seconds.
When the ON/OFF key is pressed, the equipment will display OFF for 5 s and the
ON/OFF LED will turn on.
When in this configuration, the loads and all adjustments are disabled. Press the key
once again to return the equipment to ON.
The OFF condition permits the monitoring equipment to be excluded without causing
any alarms.
NOTE: in OFF the LIGHT and AUX keys remain active.
TO VIEW THE CURRENT TIME AND DAY
1) Press the key for 3 s.
2) The following messages will appear:
Hur (hur=hour) and hour
Min (Minute0minutes) and minutes
Day and current day. Mon (Monday), Tue (Tuesday), Ued (Wednesday), Thu
(Thursday), Fri (Friday), Sat (Saturday), and Sun (Sunday)
Press the < key or wait 5 s to view the normal temperature.
TO PROGRAM THE CURRENT TIME AND DAY
1) Press the key for 3 s.
2) The time and day will be displayed
3) By pressing the SET key it is possible to set the current hour, minutes and day and
three holidays of the week.
4) To exit, press SET+<, when a parameter is displayed, or wait 15 s without pressing
SET
SE E T T
any keys.
XM470K
Combined touch with other keys
TO LOCK THE KEYBOARD
1) Keep the
and
keys pressed for a few seconds, until "POF" appears,
2) At this point the keyboard is locked: it is only possible to view the set points of
minimum and maximum temperatures.
TO UNLOCK THE KEYBOARD
Keep the < and < keys pressed for a few seconds, until "Pon" appears, blinking.
THE ON/OFF FUNCTION
428053423_2ac
• 14
GB
Richiesta
Start-Up
assegnazione
automatica
indirizzo
I
GB
F
D
E
Publicidad
