Blatchford ORION3 Guia Del Usuario página 4

2 Safety Information
This warning symbol highlights important safety information which must be
followed carefully.
Any changes in the performance or
function of the knee e.g. restricted
movement, non-smooth motion or
unusual noises should be immediately
reported to your service provider.
Always use a hand rail when descending
stairs and at any other time if available.
Any excessive changes in heel height
after programming will adversely
affect knee function and should be
immediately reported to your service
provider for reprogramming and
calibration.
After continuous use the knee casing
may become hot to the touch.
Avoid strong magnetic fields, sources
of electrical interference, atmospheres
containing liquids and/or powders.
Do not place near any heat source. Do
not leave in direct sunshine or inside a
car in hot weather.
The device is not intended for use
when immersed in water or as a shower
prosthesis.
Do not walk in water with this device.
The water resistance may prevent the
limb from extending correctly.
The device should not be used while
showering or bathing due to the
potential for seals to be compromised
by cleaning substances or detergents
and also due to the risk of slipping.
If the device is exposed to corrosive
substances such as salt water,
chlorinated water or other solutions
(including shampoos, shower gels,
soaps and body fluids) it should be
rinsed as soon as possible using fresh
water, taking care not to exceed the
water resistance limitations defined by
the IP55 rating (see
When rinsing the device only use low
pressure showers or water jets that do
not exceed a flow rate of 12.5 litres/
minute and pressure of 30 kPA (4.4 psi.)
If the device has been exposed to
significant water ingress there is
potential for a slip hazard, depending
on the floor surface, while the device is
draining.
Ensure that no solid or foreign objects
are inserted into the device, including
the drainage holes which should
only be cleaned or unblocked as
recommended in Section 4 Key Points.
Before connecting the battery charger
to the device, ensure that the magnetic
mating surfaces of the charging
connector and charging terminal are
clean, dry and free of any debris or
conductive materials that could prevent
correct charging operation. (See further
warnings in Section 6.1 and cleaning
advice in Section 4.)
1
Water resistance tested from all directions using
a water jet from a 6.3 mm (1/4") dia. nozzle at a
distance of 3 m (9.8 ft) with fresh water @12.5 litres/
minute and 30 kPa (4.4 psi) for a maximum of
3 minutes.
4
below).
1
938375BPK1/1-0723