Nordelettronica NE325 25A Instrucciones Para El Uso página 8

GB
DIP-SWITCH
on
B
S1 S2 Algorithm
( )
LED
1
ON OFF IUoU-AGM
2
OFF OFF IUoU- GEL
3
ON ON IUoU- Pb Flooded
IUoU- LiFePO4
OFF ON 4
B
( ) LED: Number of flashes of the green LED at switch on
C
( ) If the battery temperature sensor is connected, the output voltages is adapted to the temperature with dV/dT = - 24mV/°C
(respect to the output voltage without NTC temperature sensor and respect to the temperature of 25°C).
If Tbatt > 50°C the charge is momentarily interrupted and the alarm will be reset itself when the battery cools.
D
( ) If Tbatt < 0°C the charging current is reduced.
If Tbatt > 50°C the charge is momentarily interrupted and the alarm will be reset itself when the battery cools.
TECHNICAL CHARACTERISTICS:
Input voltage:
Maximum current input:
Voltage output (battery charger mode):
Voltage output (power supply mode):
Maximum current output:
Battery capacity:
Charging algorithms settable:
Fan:
Mains/status signal:
Compensation charge voltage with temperature battery:
Protection:
Weight:
CONNECTIONS:
Input/Output Battery:
Input NTC, D+, LIN:
PROTECTION:
Input: Reverse polarity
Reverse polarity
Output:
Short circuit
Overloading
Output Over-Voltage
Over-Temperature battery charger
Over-Temperature battery
(*) Depending on the value of the input voltage, can intervene the control of the maximum output power capable of limiting
the maximum input current to 48A. This prevents overheating or damage to the 50A fuse and related wiring installed as a
provision in recreational vehicles.
DC/DC NE325
without sensor NTC
with sensor NTC ( )
without sensor NTC
with sensor NTC ( )
without sensor NTC
with sensor NTC ( )
without sensor NTC
with sensor NTC ( )
NE325 25A
37A @11V
25A continuous
Compatible with the charging current of the battery charger
(check the battery charging characteristics)
no
yes (if plugged NTC sensor)
M5 screw, (use eyelet terminal d=5mm). It is advisable to make short connections
(less then 3 mt) towards the battery with minimum 10mm2 wires
Connector 4-way MOLEX MINI-FIT JR female with male terminal
(use MOLEX MINI-FIT JR male with female terminal)
pin.1 - pin.2
pin.3
pin.4
yes (with 30A fuse on the negative)
yes (with 30A fuse on the negative)
8
Voltage
C
(14,9V÷14,1V) / (14,2V÷13,5V)
C
(14,7V÷13,5V) / (14,3V÷13,5V)
C
(14,9V÷13,8V) / (14,1V÷13,5V)
D
NE325 40A
11Vdc - 15Vdc
48A (*)
see the table above
13,8Vdc
40A (*)
4 algorithm
three colour led
IP20
1,3Kg
Input NTC sensor 10K@25 B3977
Enable DC/DC - Input D+ signal (12V)
Lin-Bus Communication
yes
yes
yes
yes
yes (if plugged NTC sensor)
GB
14,7V / 13,6V
14,1V / 13,8V
14,4V / 13,5V
14,6V / 13,8V
14,6V / 13,8V
yes