SILANOS R20 Manual De Instalación De Uso página 63

ELECTRONIC GLASSWASHERS
Before powering the machine make sure that all points indicate in the page 21 -22 - 23 - 24 - 25 have been
checked.
START UP AND FILLING THE TANK.
When the door is closed press the push button 2, lamp will start flashing red and tank and boiler will start to fill.
Lamp will become green when filling of tank and boiler will be ready.
STARTING.
Wait until the machine has reached the right temperature 40 °C showed on the display, carry out one empty
cycle then place the basket in the dishwasher having removed scraps from the dishes.
Pour non-foaming washing liquid in the correct quantity as recommended by the Manufacturer.
Close the door, press button 3 to start the wash cycle.
During the cycle display will show the temperature of wash phases, wash before and rinse after, at the end of
cycle rinse temperature will be showed on display.
Please note in case of door opening wash cycle will be stopped and erased, to stat again close the door and
push the wash button cycle again.
ONGOING CYCLE
Pressing the push bottom n° 7 the ongoing cycle will start until the operator will decide to stop it, period range is
between 20 sec and 10 minutes.
DRAIN OUT WATER TANK. ( Model with drain pump ).
At the end of the day for drain out tank and boiler water: take out the over flow pipe from the tank and close the
door keeping pushed the push button 6 for six seconds.Machine will start draining the tank, end of drain will be
showed by 3 green points on display, it's obligatory switch off the machine and closing the inlet water
robinet.
REGENERATION CYCLE
Pressing bush bottom n° 4 and follows instructions at page 9. Regeneration cycle will going on for 20 minutes sho-
wed on display by a small line turning on circle. End of cycle is showed by 2 small points.
ENGLISH