Publicidad
Idiomas disponibles
Idiomas disponibles
Tape Playback
2
5413
1 Press the open/close (4) button to
open the cassette tray and load a
cassette tape.
Notes:
@ Avoid touching the tape. Fingerprints
attract dust and dirt.
@Use your finger or a pencil to turn the
cassette's hub and take up any slack
tape.
0;
S
2 Put the cassette tape on the cassette
tray with exposed part facing inward.
3 Close the cassette tray. Be careful not
to let your hand get trapped by the
closing tray.
4 Select the correct DOLBY NR type
according to how the tape was
recorded.
Each time you press the Dolby NR
button, the Dolby NR type will change
and
the
corresponding
indicator
appears on the display as follows:
DOLBY NR B—>
disappears (off)
DOLBY NR B: Select for the tape
recorded with DOLBY
B NR.
DOLBY
NR C: Select for the tape
recorded with DOLBY
C NR.
© OFF: Select for the tape recorded
without DOLBY NR.
5 Select the desired reverse mode.
Each time you press the button, the play
mode
will
change,
and
the
corresponding indicator will appear on
the display as follows:
=r
D-
Om
: Auto stop mode
uto reverse mode
: Continuous play mode
G Press the play button (<< or >).
@ >: For the forward play.
@ <4: For the reverse play.
The
corresponding
play
direction
indicator (<4 or ®) will appear and play
will begin.
7 Press the stop button to stop playing.
Notes:
@The cassette holder cannot be opened
during recording or record/pause.
@lf the power
has been switched off
during play or recording, ejecting the
Cassette may be impossible. In such a
case, switch the power on and press the
open/close button again.
Skip Play (CPS) Function
2
While playing, you can skip to the desired
music item in either the forward or reverse
direction with this CPS (Computomatic
Program Search) function.
You can preset up to the 9th music item.
1 Press the play (< or >) button.
2 Press the CPS (<</\<< of > >i/>P)
button.
When
pressing
the
>P/ mr
or
4/i4<button,
the
digital
tape
counter display will be replaced by the
program display.
Press the button repeatedly until the
number of the program you want to
start playing is displayed
mPi/ee:
When
you
press
this
button, 1, 2, 3, etc. will be
displayed during forward
play; -1, -2, -3, etc. during
reverse play.
<4</i44:
When
you
press
this
button, -1, -2, -3, etc. will be
displayed during forward
play; 1, 2, 3, etc. during
reverse play.
Note:
@In the following cases, searching may
not work normally but it is not a failure.
1) The interval between the music items
on the cassette tape is too short (less
than about 4 seconds).
2) The running time of a music item is too
short (less than about 15 seconds).
3) There is an area of lower level or mute
in the middle of a music item.
Publicidad
