Publicidad
PROGRAMMING INSTRUCTIONS
Before starting learn mode, the shutters must be positioned close to the "open" position (approx. 10 to 15 cm).
The programming status is confi rmed by the blinking of the green LED
Learning mode (green LED)
Push once for more than 5 seconds on the Push button on the rounded board
The green LED will blink fast (|.|.|.), the learning mode has now started.
The shutters slide up to the opening stop positions and then to the closing stop position in order to save the travel distance. This
occurs at slow speed.
A second opening/closing cycle occurs at normal speed.
The learning mode has been completed.
Programming of an transmitter (green LED)
Press briefl y (less than 2 second) on the push button on the rounded board
The LED will light up.
Press on both transmitter buttons once simultaneously for more than 1 second.
The setting of the transmitter will be confi rmed by a rapid blinking of the LED ( . . . )
Deleting of all transmitters (green LED)
Quickly press the push button twice for less than 2 seconds.
The LED will blink quickly ( . . . )
Then press again on this button and hold for more than 10 seconds till the LED goes out.
The entire memory has been deleted.
Use the RELAY output (1A 30VDC ; 0.5A 110VAC) :
To use the relay output, switch ON the 3d switch on the Rounded board
The relay will be switch ON when the shutter start to open
Switch off when the shutters will close.
DIAGNOSTIC AID
Problems
The learning cycle does not start
The learning cycle does not start The
red LED fl ashes 1 time every 4 seconds
The learning cycle is complete but
the transmitter does not operate the
shutters The red LED fl ashes 5 times
rapidly
The open command starts the closing
of the shutter
The shutter does not open on a request
for
The shutter does not close completely
The shutter does not open completely
The drive is noisy (clack noise)
NM V313
A
09-2012
Probable causes
The control unit is not powered
The gear motor is not connected to the
control box
No Control device is connected to the
control box
command reversed
The control is defective
Presence of an obstacle or bad learning
Presence of an obstacle or bad learning
Unstrung belt
MANTION SAS
- 25000 Besançon - Tel +33 3 81 50 56 77 - Fax +33 3 81 85 38 79 - www.mantion.com
red LED
green LED
BP
Solutions
Check that the power supply is
properly connected to the mains (see
manual)
Check the connection motor/control
unit (see instructions)
Proceed with programming of the radio
transmitter (see instructions) or check
the connection of wired button
Re learning by positioning the fl ap at
10cm from the closed position.
If the problem persists, restart learning
by positioning the fl ap 10cm open
position
For wired, check the connection of the
button. For the radio, check that the
batteries are not defective (LED lit on
button pushing)
Remove the obstacle and / or
re-learning
Remove the obstacle and / or
re-learning
Check the belt tension. It should be
neither unstrung nor too tight.
15/16
Publicidad
