Trouble Shooting - autoXS 44266 Manual Del Usuario

600 Peak Battery Amp Jump Starter
PROBLEM
POSSIBLE CAUSE
The power pack Clips are not making a good
won't jump start connection to the battery.
my car.
Connections are reversed.
The power pack battery
is not charged.
The vehicle's battery
is defective.
The power pack The 12V device is not
won't power my turned on.
12V device.
The power pack battery
is not charged.
The 12V device draws more
than 15A or has a short
circuit.
The battery in the The battery is bad (will
power pack won't not accept a charge).
hold a charge.
12
acs@americancustomerservice.com

TROUBLE SHOOTING

Check for poor connection to battery and
frame. Make sure connection points are
clean. Rock clips back and forth for a
better connection.
Disconnect the power pack and reverse
the clips.
Check the battery charge status by
pressing the button on the front of the
power pack. See LED Indicators section
of this manual.
Have the battery checked.
Turn on the 12V device.
Check the battery charge status by
pressing the button on the front of the
power pack. See LED Indicators section
of this manual.
Disconnect the 12V device and press the
reset button located on the back of the
power pack. Try the 12V device again. If
it happens again, replace the 12V device.
Have the battery checked.
USA
Trouble Shooting
REASON/SOLUTION
AFTER SALES SUPPORT
800-505-8311
USA