Concept QH4100 Manual página 30

EN
PRODUCT DESCRIPTION
1 Main switch 0/I (on/off)
2 Outlet grille
3 Display
4 Remote control
5 START/STOP button (manual start without using the remote control)
Display
A Power supply
B Temperature
C Minimum input
D Maximum input
E Oscillation
F Temperature indicator
G Ambient temperature
H Set temperature
I
Hours/Minutes
N Open window function
P Day timer
Q Days of the week (MO-Monday, TU-Tuesday,
WE-Wednesday, TH-Thursday, FR-Friday, SA-
Saturday, SU-Sunday)
Remote control
1a On/Off
2b Power setting
3c
Open window function
4d Oscillation
5e Day timer
6f Child lock function
9i + button
10l – button
11m Time/date setting
The remote control comes with a battery (type
CR2025, 3 V). Remove the protective film before
first use.
58
MOUNTING THE DEVICE ON THE WALL
The appliance is designed to be wall-mounted. Installation may only
be performed by a qualified person.
Before installing the appliance, make sure that there are no electrical
cables or water pipes in the place of installation.
Place the appliance at least 2 m above the floor, 25 cm from the
corner of the room and 20 cm below the ceiling. Air outlet hole must
be directed downwards (see Fig. 1).
Drill two holes in the wall according to the holes for hanging on the
back of the device.
Insert the dowels into the holes and screw the screws into them so
that they protrude 5 mm from the holes.
Hang the appliance on the screws and make sure that it is properly
installed.
OPERATING INSTRUCTIONS
1. Before plugging in the appliance, make sure that the main switch I/O is in the O (Off) position.
2. Place the heater on a solid stable surface and switch the main switch to the I position (On). You will hear a sound
signal, the device is in the standby mode.
3. Press the On/Off button on the remote control or START/STOP directly on the appliance to turn on the heater -
operating mode.
Time and date setting (only in operating mode)
1. Press the Set button (11m) and by pressing the +/- buttons (9i/10l) set the day.
2. Press the Set button for the second time (11m) and by pressing the +/- buttons (9i/10l) set the hour.
3. Press the Set button for the third time (11m) and by pressing the +/- buttons (9i/10l) set the minute.
4. Press the Set button for the fourth time (11m) – time and date are saved.
Note: If there is a delay of more than 5 seconds between each pressings of the buttons, the current setting will be
saved automatically.
Warning: When the appliance is turned off by pressing the main button O/I, due to a power failure or unplugged
power cord, the time and date settings will be lost.
Manual operating mode setting (only in operating mode)
1. Press the On/Off button (1a) and put the device into operating mode.
2. Press the Mode button (2b) and select the desired mode:
- Warm air, power 1000 W (C)
- Hot air, power 2000 W (D)
- Fan function (no icon on the display)
3. Press the Swing button (4d) to activate/deactivate automatic air oscillation.
EN
Fig. 1
Fig. 2
59