ENGLISH
Recommendations
- It is not suggested to use the scrubbing function for the first-time use.
- Do not use the mopping function if the robot vacuum cleaner is not being supervised.
- To remove the mop bracket, press the release button and pull from it outwards.
- Uninstall the mop bracket when the robot vacuum cleaner is charging or when not
in use.
- Add a few drops of cleaning agent to the water, if necessary, as long as it is non-
corrosive.
- Using cleaning agents in excess might block water outlets.
- In order to achieve perfect scrubbing, it is suggested to moisten the mop before
using it.
First use
- Once the robot vacuum cleaner and the self-emptying base are installed, follow
these steps before the first cleaning.
- First of all, fully charge the robot vacuum cleaner. It is suggested to allow the robot
to charge overnight. Once fully charged, it may carry out the first cleaning cycle and
save the first map. To do so, activate the Auto mode and select the Eco suction level.
It is very important to follow these instructions so that the robot vacuum cleaner
recognises every corner of your house and can carry out a complete mapping of it.
If your house is very large and the robot vacuum cleaner runs out of battery, it will
return to the self-emptying base, save both complete and incomplete maps, and,
once charged, it will resume cleaning where it left off until the entire surface has
been mapped. The robot vacuum cleaner is constantly mapping, so it adapts in
an individualised and personalised way to the particularities of each house while
constantly improving its map.
3. OPERATION
Robot vacuum cleaner's buttons
Automatic mode
- Press the Start/Pause button on the robot vacuum cleaner or select it in the app
to make it start cleaning automatically in Edge mode and then perform a cleaning
cycle in an orderly zigzag pattern while it also recognises which areas have been
cleaned and which have not. The robot will automatically plan the cleaning route as
33
EVVO ROBOT ASPIRADOR R9D LÁSER