Toolland VL2301 Manual Del Usuario página 6

7. Operation
7.1 Before Starting
Before starting, ensure that the hose is correctly fitted. Also, ensure that the function selection lever is in the
normal position and is not obstructed by debris from the previous use.
Inspect the area you wish to clear. Remove all debris and objects likely to be thrown away by or get stuck into
the leaf blower.
Also, leave vegetal debris to dry before vacuuming as fresh leaves contain a large amount of water and can get
stuck inside the hose.
7.2 Starting the Leaf Blower
1. Select one of the two functions using the
function selection lever [g].
2. Connect the leaf blower to the mains.
3. Squeeze the on-off trigger [h] to switch on the
leaf blower.
4. If desired, increase the power with the speed
control [i].
7.3 Using the Leaf Blower
After the leaf blower has been switched on, rest the hose on the castors and push it forward, pointing the end
of the hose towards the debris.
A second method is to hold the hose just above the soil and move the leaf blower from side to side while
moving forward slowly.
As a rule, do not rush and take your time as leaves and other debris can obstruct the hose.
Switch off the leave blower and disconnect from the mains after use. Make sure to carefully empty the bag to
avoid rotting debris.
V. 01 – 24/05/2016
VL2301
6 ©Velleman nv