PRIXTON XP1 Manual De Instrucciones página 5

EN
1. lntroduction to the product
Thank you for choosing a Prixton brand product.
2. Components
1- Lever
2- Cone cover
3- Pulp filler
4- Juice holder
5- Anti-drip system
6- Cone cover release button
7- Cone
8- Main body
3. Technical specifications
Voltage: 220~240V 50/60Hz Power: 160W Current: 2.5A KB: 15S
4. Use
To extract juice:
Lower the anti-drip system and place a recipient underneath it. Slice an orange, lemon or
other citrus fruit in two and place one half on the cone. Press the lever down and the
motor will engage. Apply only the force required for the juice to flow.
IMPORTANT precautions :
1) Place the fruit piece carefully and correctly on the cone in order for the juice to flow
correctly.
2) Please do not press the lever too hard. lf you do so the juicer will block in order to
protect the gearing system. The pressure exerted should not exceed 3 kg. For correct
operation press the lever for 15 seconds then release and leave for a further 15 seconds.
3) By lifting the cone cover you can finish juicing the fruit by hand, if necessary. This
method is also suitable for fruits that do not adjust to the cone size.
4) This juicer features a safety system that ensures correct operation. lf the motor reaches
a temperature of 120ºC due to intensive use it will block and cannot be used again until
the desired temperature is reached - normally about ten minutes, though this will depend
on the ambient temperature.
5. Safety precautions
When using domestic appliances a series of basic safety precautions should be taken,
including those listed below. Please read them carefully.
1) When using the machine, place it on a flat surface and use it in accordance with the
times indicated above.
2) For every ten pieces of fruit you juice, wait ten minutes before reusing the machine.
3) Do not leave the machine unattended when in operation. To avoid accidents keep the
machine out of the reach of children.
4) Do not use high temperature sterilisation methods with any of the accessories.
5) Should the power cable suffer any damage or deterioration it should be repaired or
replaced by the manufacturer or authorised personnel.
6) Do not overload the juicer under any circumstances, and do not operate it without any
fruit.
5