Maintenance And Inspection - Hitachi M 12V Manual De Instrucciones

English
Fig. 23
3. Model M12V(S), M12SA(S), M8V(S), M8(S)
(1) Dust corrector set
Used to collect cutting particles by connecting a cleaner.
(2) Scale (Unit : mm)
Used when setting the cutting depth in mm units.

MAINTENANCE AND INSPECTION

WARNING:
1. Adjusting the lock lever position:
Fig. 24
2. Oiling:
To ensure smooth vertical movement of the router, occasionally apply a few drops of
machine oil to the sliding portions of the columns and end bracket.
3. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened.
Should any of the screws be loosened, retighten them immediately.
WARNING:
20
Be sure to switch power OFF and disconnect the plug from the receptacle
during maintenance and inspection.
Using this router with loosen screws is extremely dangerous.
(2) Feed screw ass'y
The feed screw assembly can be used to make
fine adjustments in the distance between the bit
and the parallel guide or trimmer guide. Attach
the feed screw to the parallel guide or the trimmer
guide as shown in Fig. 23, and then attach the rod
to the base using the nuts provided. Turn the
feed screw to make fine adjustments. Push the
button on the feed screw to release the grip of
the screw and allow fast movement of the guide.
The lock lever part is provided with a brass lock
piece to protect the column. When the lock piece
becomes excessively worn, the lock position of the
lock lever tends to drop. Should router operation
and handling become difficult as a result, remove
the E-type retaining ring and adjust the setting
position of the dodecagonal hole on the lock lever
and the hexagonal axis of the lock screw, as shown
in Fig. 24.