Viper 4218V Guía De Propietario página 7

Idiomas disponibles

Government Regulations

This device complies with Part 15 of FCC rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may cause undesirable

operation.

This equipment has been tested and found to comply with the limits for a class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-

able protection against harmful interference in a residential installation. This equipment

generates and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio com-

munications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television, which

can be determined by turning the equipment OFF and ON, the user is encouraged to try

to correct the interference by one or more of the following measures:

Re-orient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio / TV technician for help.

This device complies with the Industry Canada Radio Standards Specification RSS 210. Its

use is authorized only on a no-interference, no-protection basis; in other words, this device

must not be used if it is determined that it causes harmful interference to services authorized

by IC. In addition, the user of this device must accept any radio interference that may be

received, even if this interference could affect the operation of the device.

Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate this device.

Warning! Safety First

The following safety warnings must be observed at all times: Due to the complexity

of this system, installation of this product must only be performed by an authorized

Directed dealer.

When properly installed, this system can start the vehicle via a command signal from the

remote control transmitter. Therefore, never operate the system in an enclosed area or par-

All manuals and user guides at all-guides.com