Sears Craftsman 171.28140 Manual Del Propietário página 24

USING THE ROUTER TABLE
ATTACHING AND USING A
WET/DRY VACUUM
/AWARNINGI Before connecting vacuum
LR I to router table switch box,
ensure that the vacuum switch is OFF, and
that the router table switch box is unplugged.
Such precautionary safety measures reduce the
risk of unintentional tool operation.
/ A WARNINGI Do not exceed a total
L_ I combined
rating of 15
amps when connecting the router and any
accessories such as a light or wet/dry
vacuum. The switch has a rating of 15 amps.
The fence assembly has a port for connecting
a wet/dry vacuum hose with a 21&-in. nozzle.
To attach, simply push the nozzle into the port
while holding the fence assembly in place.
The vacuum can be plugged into the router
table switch box. Be sure the cord does not
interfere with router operation.
IACAUTIONI Operating the router table
I" ] without a wet/dry vacuum can
result in an excessive buildup of sawdust and
wood chips under the fence assembly and
guard, reducing the performance of the router
table and fence assembly.
RECOMMENDATION: To maximize
performance, regardless of whether a wet/dry
vacuum is being used, remove the sawdust
and wood chips from under the fence
assembly and guard as needed.
RECOMMENDATION: It is always a good
practice to keep the work area clean. As
necessary, remove any accumulated sawdust
and wood chips from the top of the router table, as
well as from the surrounding work area and floor.
/AWARNINGI Never place your fingers
[" I near a spinning
bit or
under the guard when the router is
plugged in. Such precautionary safety
measures reduce the risk of personal injury.
INSTALLING THE ROUTER BIT
(CUTTER)
/ A WARNINGI Disconnect the router
LAUk I from the power supply
before making adjustments or changing
accessories. Such precautionary safety
measures reduce the risk of unintentional tool
operation.
Install the router bit according to the instructions
included with your route£ Because of the large
variation of router bits, certain router bits may
not always operate in the desired manner with
this router table.
To ensure that the most popular bits will perform
satisfactorily, install the bit so that the router
collet engages 3/4 in. of the router bit shank.
If the shank of the router bit bottoms out in the
collet, back out the router bit approximately
1/16 in. to allow for proper tightening.
NEVER INSTALL ROUTER BITS WITH
LESS THAN 3/4 IN. OF SHANK
ENGAGEMENT IN THE COLLET.
24