Publicidad
• Bedienung • Operation • Utilisation • Bediening •
• Istruzioni per l´uso • Funcionamiento •
K
A
B
3005 DE-ES 08-2022 9700128 20230222zm
EN Using the optical cutting line
indicator
• Cutting line
blade lever
blade lever is in upper position and
paper is inserted the cutting line
line) is clearly visible.
• Switch
K
"AUTO ON":
Cutting Line is automatically lighted up
when feed table
Cutting line goes automatically off when
feed table is closed.
• Switch
K
"OFF":
Cutting line is completely switched off.
• On the right side the cutting light
visible over a length of 10 cm.
• There is a possibility that the cutting
line cannot be seen well in extremely
bright place.
• Exchange batteries if the cutting line
becomes dark.
• Switch off the cutting line after using the
cutter, to avoid the consumption of the
battery.
• Remove the batteries in case the
cutter is not used for a long time.
• Position of trimming (B) is at the rear
edge of the cutting line (A = width).
18
I
is not visible if
is in lower position. If the
A
G
is opened.
I
(red
I
is
Publicidad
