Publicidad
Idiomas disponibles
Idiomas disponibles
THIS TOOL MUST BE GROUNDED WHILE iN USE TO
PROTECT THE OPERATOR FROM ELECTRIC SHOCK.
iN THE EVENT OF A MALFUNCTION
OR BREAK-
DOWN, grounding provides the path of bast resistance
for eUectric current and reduces the risk of eUectric
shock, This tooUis equipped with an eUectric cord that
has an equbment-grounding
conductor and a ground-
ing pUug, The pUugMUST be pUugged into a matching
eUectrbaUreceptacb
that is properUy installed and
grounded in accordance with ALL bcaU codes and
ordinances,
DO NOT MODIFY THE PLUG PROVIDED, If it will not
fit the electrical receptacb, have the proper electrbal
receptacb
installed by a qualified electrician,
IMPROPER ELECTRICAL
CONNECTION
of the equip-
ment-grounding
conductor can result in risk of electric
shock, The conductor with the green insulation (with or
without yellow stripes) is the equipment-grounding
conductor, DO NOT connect the equipment-grounding
conductor to a live terminal if repair or replacement of
the electric cord or plug is necessary,
CHECK with a qualified electrician or ser4ce personnel
if you do not completely understand the grounding
instructions, or if you are not sure the tool is properly
grounded,
The motor supplied with your Dust Collector is a dual
voltage 120/240 volt, singb-phase
motor, It is shipped
wired for 120-volt application,
Never connect the green
wire to a live terminal, See OPERATING DUST
COLLECTOR
section for directions on changing motor
voltage,
USE ONLY A 3-WIRE EXTENSION CORD THAT HAS
A 3-PRONG GROUNDING PLUG AND A 3-POLE
RECEPTACLE
THAT ACCEPTS THE TOOL'S PLUG.
REPLACE A DAMAGED OR WORN CORD IMMEDI-
ATELY.
Fig.
1
GROUNDED
OUTLET
BOX
CURRENT
CARRYING
GROI;3_
USLONGEST OFTHE 3 BLADES
HOLES
Fig.
2
GROUNDED OUTLET BOX--
GROUND|NG
MEANS
HOLES
Fig. 3
GROUNDED OUTLET BOX
CURRENT
CARRYING
PRONGS
24O
VOLT
GROUNDING BLADE
BLONGESTOFTNE3BLADES
O
This tool is intended for use on a circuit that has an
electrical receptacle as shown in FIGURE !, FIGURE 1
shows a 3-wire electrical plug and electrical receptacle
that has a grounding conductor, If a properly grounded
electrical receptacle is not available, an adapter as
shown in FIGURE 2 can be used to temporarily connect
this plug to a 2-contact ungrounded receptacle, The
adapter has a rigid lug extending from it that MUST be
connected to a permanent earth ground, such as a
properly grounded receptacle box, THIS ADAPTER
IS
PROHIBITED
IN CANADA.
A tool with a 240-volt plug should only be connected to
an outlet having the same configuration as the plug
shown in FIGURE 3, No adapter is available or should
be used with the 240°volt plug,
CAUTION: in all cases, make certain the electrical
receptacle in question is properly grounded, if you are
not sure have a certified electrician check the electrical
receptacle,
This Dust Collector is for indoor use only, Do not
expose to rain or use in damp locations,
Publicidad
