Publicidad
Idiomas disponibles
Idiomas disponibles
Customer Responsibilities
Check Safety Valve
Drain Tank
Check Oil
Change Oil
Unusual Noise and/or
Vibration
Air Filter
Drive Belt-Condition
Motor Pulley/Flywheel alignment
Air compressor pump intake
and exhaust valves
Inspect air lines and fittings
for leaks
Head Bolts - Check the torques of the head bolts after the first five hours of operation.
1- more frequent in dusty or humid conditions
2- more frequent if humidity or operating conditions are extreme.
sources, compressed air, or moving parts. Personal injuries can occur.
Before performing any maintenance or repair, disconnect power source
from the compressor and bleed off all air pressure.
To ensure efficient operation and longer life of the air compressor outfit, a
routine maintenance schedule should be prepared and followed. The following
routine maintenance schedule is geared to an outfit in a normal working
environment operating on a daily basis. If necessary, the schedule should be
modified to suit the conditions under which your compressor is used. The
modifications will depend upon the hours of operation and the working
environment. Compressor outfits in an extremely dirty and/or hostile
environment will require a greater frequency of all maintenance checks.
NOTE: See "Operation" section for the location of controls.
To Check Safety Valve
properly, over-pressurization may
occur, causing air tank rupture or
an explosion.
MAINTENANCE
Before
each
use
Unit cycles automatically when power is on. When
performing maintenance, you may be exposed to voltage
If the safety valve
does not work
Every
Every
8
40
hours
hours
1
1.
Before starting compressor, pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the valve is
stuck or does not operate
smoothly, it must be replaced
with the same type of valve.
17-ENG
Every
Every
Every
100
500
160
hours
hours
hours
2
Yearly
2
D26059
Publicidad
