Publicidad
Installation
1
Instalación
Installation
1. Pre-Installation - Control Location
a. The control must be installed inside the steam room. For convenience the recommended height from the floor is four feet. Provide a 1 1/2"
hole in the wall at this location (see Figure 2). Mount control near the seating area on the opposite or adjacent wall from the steam head.
The control and steam head should be as far apart as possible and NOT above or not within 4' to the right or left of the steam head.
IMPORTANT: Multi-conductor cable must be installed so that the end will not be buried inside the wall. The unit will not operate unless the
control is installed.
2. Electrical Rough-in
a. Remove the multi-conductor cable from the control packing box. Carefully route the multi-conductor control cable from the steam
generator to the control located inside the steam room. (See Figure 2 and Figure 3). Route multi-conductor cable through a 3/4" conduit to
protect the cable from damage and to facilitate replacement if necessary.
3. Control and Cable Installation
a. Locate the previously installed cable and black plastic strain relief clamp (1) which is in the control packing box. Locate the knockout (2) on
the steam generator for the control cable (see Figure 3).
b. Place strain relief around cable, about 7" from the end and insert into hole.
c. Connect the cable to the modular jack (3).
d. Close and secure generator cover.
e. Locate modular jack and female coupler (4), on back of the EP103305 or 5P-EST Series Control. Plug cable into jack. Check that the
orientation of the plug properly aligns with the jack. A snap will indicate the plug is installed correctly. (See Figure 2).
f. Peel adhesive liner from back of the control. Apply the control to the wall. Press firmly and hold for a few seconds.
g. After the control is in place, apply silicone (supplied) around the control to form a watertight seal.
WARNING
!
Test the control for operation before continuing on to the next step.
4
1
2
3
3
113379 Rev. B
Publicidad
