Publicidad
Idiomas disponibles
Idiomas disponibles
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. Always attach plug to appliance first, then plug cord into wall outlet. To disconnect, turn any control to
OFF position, then remove plug from wall outlet.
12. Oversized foods or metal utensils must not be inserted in the appliance as they may cause a fire or
risk of electrical shock.
13. A fire may occur if the appliance is covered or touching flammable material including curtains,
draperies, walls and the like when in operation.
14. Do not clean with metal scouring pads. Pieces can break off the pad and touch electrical parts,
involving a risk of electrical shock.
15. Extreme caution should be exercised when using containers constructed of other material other than
metal or glass.
16. Do not store any materials other than manufacturers recommended accessories in this unit when not
in use.
17. Do not place any of the following materials inside the unit: Paper, cardboard, plastic and the like.
18. Do not operate the appliance exceed 1 minute.
After that the appliance need to cool down for not overheating.
Before first use:
All parts of the blender are to be thoroughly cleaned before being used for the first time.
Take out the required length of cable from the cable tidy on the base of the blender and connect the
device to the mains supply.
Assembling the Jar:
1.
Put the rubber sealing ring (5) on the inner edge of the blade unit (6).
2.
Put the blade unit with sealing ring into the cup base (7).
3.
Inset the safety ring (4) on the bottom of jar first, then Insert the assembled cup base onto the bottom
of the jar and secure tightly.
4.
Mount the jar(3) onto the cup base unit and tune the cup base unit, and turn clockwise until jar locks
into place.
5.
Mount the Measure Cup (1) onto the Lid (2).
6.
Secure the Lid onto Jar and press down.
Inserting the Jar:
1.
Make sure that the blender is switched off (Switch in the '0' setting).
2.
Place the jar assembly (3) on to the motor base (8) and press down until securely engaged.
How to Use
1.
Place the foodstuff you wish to process into the jar.
2.
Put the lid on the jar and close securely. Place the measuring cap into the hole in the lid and turn
clockwise to lock.
3.
Switch on the motor base:
Publicidad
