Wilfa Haze HU-400BCA Manual De Instrucciones página 20

EN
Display show
error code E1.
The following is not considered faulty operation:
• If your water is very hard (containing abnormally high levels of minerals) the
humidifier may produce white dust. This is not a malfunction. The solution
would be to clean the filter more often or use softer water.
• If you stand very close to the humidifier, you will hear the gurgling sound of
water. This is normal.
• The humidifier operates very quietly but it is not completely silent. Noise
levels less than 35dB(A) is considered normal.
INSTRUCTION MANUAL · HUMIDIFIER
Water detector PCB is
defective.
Water detector PCB
factory setting failed
Water detector PCB is
defective.
18
Contact Customer Support.
Follow the steps to reset: Reset
process must be completed
within 1 minute after humidifier
is plugged in (step 2).
• Remove the water tank,
empty water in the base.
• Plug the humidifier in.
• Press POWER ICON 2 times,
then PRESS AND HOLD
POWER ICON for 2 seconds.
Display will show PL and then
PA.
• Press POWER ICON 1 time.
• Unplug the humidifier. Reset
is finished.
• Set up humidifier and plug in
to run the humidifier for use.
If RESET does not resolve
E1 Code, contact Customer
Support.
Contact Customer Support.