AstroAI GL-1402A Manual Del Usuario página 6

CHECKING TIRE PRESSURE
The inflator gauge can be used to check tire pressure without
connecting to an air compressor.
Use one of the interchangeable air chucks to connect the inflator
to the tire's valve stem. Press the air chuck tight to prevent air
leakage.
Press the Power/Unit button to turn on the tire inflator gauge,
press it again to choose the desired unit.
NOTE: What to do if air leaks through the chuck?
a. Connect the chuck to the tire valve and press hard to get a good seal.
b. Rotate the chuck clockwise 180°-360° to stop the air from leaking.
Release excess air by using the Air Bleed
5.
Valve / Reset button. If the tire's pressure
is higher than the desired level, press the
Air Bleed Valve to decrease the pressure.
NOTE: While bleeding air from the tire, the
pressure reading will not indicate the
exact pressure of the tire. To check on the
tire's current pressure, release the Air
Bleed Valve and the display will instanta-
neously show the tire's pressure.
6. The gauge will automatically shut o
20-60 seconds after use. The gauge can be
manually turned o by holding the Power/
Unit button down for more than three
seconds.
- 05 -
EN