LED Flashes:
1 blink
2 blinks
3 blinks
4 blinks
5 blinks
6 blinks
7 blinks
PROGRAMMING
18
ALARM
TURN ON
DISABLED
IGNITION
MASTER BUTTON
1 BEEP ACTIVATED
2 BEEPS DEACTIVATED
Nº of Beeps
1
Programming controls
Adjustment of ultrasound sensiti vity
2
(see secti on 15)
3
Automati c lock (auto-lock)
Lock pulse ti me:
4
1 Beep: 2,5 segs / 2 Beeps: 0,8 segs
Expansion
•1 Beep: 14s •2 Beeps: 0,2s (GM)
5
ti me:
•3 Beeps: VW G5 •4 Beeps: FIAT
6
Anti -theft for opening the door
7
Anti -Theft For Starti ng Igniti on
8
Automati c lock
9
Enable / Disable alarm
10
Enable / Disable alarm with blinkers
11
Enable / Disable alarm with beeps
12
Factory Confi guarati ons
20
Descripti on
Remote control panic
Movement inside the vehicle (ultrasound)
Door/hood sensor
Igniti on key
Block
Ba� ery cut (power supply of alarm)
Ultrasonic receiver problem
PRESS THE
LISTEN CONSECUTIVE
BEEPS OF THE FUNCTIONS
RELEASE THE MASTER BUTTON
AT THE DESIRED FUNCTION
Functi on
Defaut Confi g.
3 Beeps
Enabled
0,8 seconds
14 seconds
Disabled
Disabled
Enabled
Enabled
Enabled
Enabled
Aft er the 12º beep, a long beep will sound indicati ng that you are leaving programming
mode without making any changes. Turning the igniti on off also exits programming
mode and the alarm will respond with a long beep. In this case, the programming is
not changed.
ALARM SIGNALS
19
Signal
Emi� ed
Lock
Negati ve
Unlock
Negati ve
Sound Control
12V
Blinker
12V
Lockdown
Siren
Positi ve
dedicated
Expansion
Negati ve
Auxiliary
Negati ve
Door
Trunk/Hood
Accessory Positi on
20
ULTRASOUND SENSOR INSTALLATION
Connect all the wires (signals and power)
of the alarm according to the installati on
diagram (see secti on 22);
Clean the locati on for the ultrasonic
capsules. It is recommended that the
capsules be installed 15 cm from the
top-down
windshield.
For
opti mal
performance, a� ach them as shown to
the side. If necessary, adjust the ultrasonic
sensors aft er installati on (see secti on 18).
Received
Maximum
200mA
200mA
150mA
10A
350mA
200mA
200mA
Negati ve
Negati ve
12V
LED
21