Suncast BMS6284 Instrucciones De Armado página 14

Assembly-Roof
Place roof on flat surface and lower support bracket (J)
into channel on under side of roof panel ( H). Support
bracket (J) top hole must be on the right side for proper
orientation. Align holes in truss leg to rockets on roof
panel. Attach bracket using ten screws ( HH).
Note: Support bracket must be installed in orientation shown
above. Roof will not fit if bracket is installed backwards.
0 0
0 0
0 ' 0 0
gee
... ` e
.
g " Ce?,
* e
h
e.
%
.0
e
e
P e tz.
i
e e c. e
ea.
e e
Lower roof bracket (L) into position on roof. Secure
bracket with easy bolt. Use easy bolt easy driver ( FF)
to hand tighten. Easy bolt head will be flush when fully
seated. Do Not over tighten easy bolts.
Lower S- rail ( I) into position on roof ( H). Attach using
ten screws ( HH). S- bracket ( I) proper orientation is
shown above.
Note: There are no pre-drilled holes on the roof. Use force
when starting to drive self-tapping screws. Once the screw
pierces the plastic, it will drive easier.
14
Attach door clip brackets ( II) to bottom of roof panel ( H)
using two screws ( HH).
Note: The vertical portion of the bracket must be oriented
towards the inside of the shed.
14