Publicidad
Idiomas disponibles
Idiomas disponibles
DMX connection
If you make your own cables, please note the figures on this page. Do not connect the cable shield to
the ground contact of the connector or allow the shield to come into contact with the XLR connector
housing. If the shield comes into contact with the ground, it may lead to unstable operation of the
equipment. To avoid system errors, a termination resistor (120 ohms, 1/4 W) should be connected to the
last fixture in the DMX chain.
1. Common (Mesh)
2. Data 1- (Primary Data Link)
3. Data 2+(Primary Data Link)
4. Data 2- (Secondary Data Link)
5. Data 2+(Secondary Data Link)
9
Publicidad
