NeuLog NUL-215 Guía General página 19

Probe usage and care
The probe has two flat electrodes with known surface
areas and distance between them. A signal is supplied
to the electrodes and by testing the signal behavior, the
conductivity of the solution is calculated.
General care:
 During measurements, make sure that the electrodes
(in the shape of a circle with a dot inside) are covered
by the liquid.
 Avoid as much as possible touching the probe's flat
surface.
 Never submerge the probes plastic body in any liquid.
 Gently rinse the probe with distilled water after each
use and between samples to avoid damage and
contamination.
 Handle and store with care to avoid damaging or
chipping the probe.
V2018.01
19
Home
English