SSP MCC402 Manual De Instrucciones página 7

013756
To install the diamond wheel, follow the removal
procedure in reverse. Always install the diamond wheel
so that the arrow on the diamond wheel points in the
same direction as the arrow on the blade case. BE
SURE TO TIGHTEN
COUNTERCLOCKWISE SECURELY.
Hex wrench storage
1
013757
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Water flow (Optional accessory)
Only for tool with a water pipe
013759
First, unplug the tool. Loosen the wing bolt on the depth
guide and move the base down. Install the water pipe
on the blade case and secure it by the screw.
Attach the vinyl tube onto the water pipe and attach the
adapter on the vinyl tube to a faucet of water mains
pressure. Adjust the amount of water flow by simply
adjusting the water cock.
1. Inner flange
2. Diamond wheel
3. Outer flange
4. Hex bolt
1
2
3
4
THE HEX BOLT
1. Hex wrench
1. Water cock
2. Wing bolt
1
3. Water pipe
2
3
Only for tool with a vinyl tube
013760
Put the vinyl tube into the tube holder just like screwing
in so that used diamond wheel cannot be obstructed or
interrupted.
OPERATION
CAUTION:
This tool should only be used on horizontal
•
surfaces.
Be sure to move the tool forward in a straight line
•
and gently. Forcing and exerting excessive
pressure or allowing the diamond wheel to bend,
pinch or twist in the cut can cause overheating of
the motor and dangerous kickback of the tool.
013763
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the diamond wheel making any contact.
Then turn the tool on and wait until the diamond wheel
attains full speed. Now simply move the tool forward
over the workpiece surface, keeping it flat and
advancing smoothly until the cutting is completed. Keep
your cutting line straight and your speed of advance
uniform.
7
1. Tube holder
2. Vinyl tube
1
2