Grupel GR3000 Manual Del Operador página 53

a. The generator can be started by
placing the engine switch in the START
position.
STOP THE ENGINE
1. Remove all loads from the generator.
b. Pull the recoil starter grip until the
engine starts.
NOTE: Do not allow the grip to snap
back after starting; return it slowly to its
original location. Allow the engine to
run for 10-20 seconds, then move the
choke lever to the RUN position.
5. To operate electrical equipment, turn
on the AC circuit breaker.
When using multiple devices at the
same time, do not add any more, unless
the generator and other items are
operating normally.
The total power of the loads must not
exceed the rated power of the unit.
2. Set the engine switch to the OFF
053
position.