Use Instructions
3
2
The crevice tool is used to clean the dust in the wall corners and other gaps.
1
The brush tool is used to clean the sofa and carpets.
2
The flexible hose is used to clean some area that hard to reach (under the
3
bed or sofa) or clean the car.
Charging and Storage
1.
If the battery temperature is below 0 °C, the machine will be turned off to pro-
tect the motor and battery. Do not charge the product and store it at a tem-
perature below 0 °C.
2.
To extend battery life, please avoid charging immediately after full discharge,
the product needs to be cooled for a few minutes.
3.
Avoid using the product when the battery surface is hot. Running the machine
at a low temperature helps to extend the working time and service life of the
battery.
1
10
4.
If you do not use the vacuum cleaner for a long time, remove the battery from
the battery compartment and place it in a cool place.
Notice
Please fully charge the vacuum cleaner before first use.
The vacuum cleaner can not be used to suck liquid. If the liquid is sucked,
the motor will be damaged, resulting in a short circuit or other problems.
Before using the vacuum cleaner, check whether the suction head and ac-
cessories are clean.
The brush may damage some carpets or floors. When using this product
for cleaning, the hard brush roller may cause some carpets to fluff. If it hap-
pens, please do not use the brush head when vacuuming and consult the
carpet manufacturer whether the carpet can be cleaned by the vacuum
cleaner.
Troubleshooting
1.Low suction or almost no suction
The product in normal mode can work up to 25-30 minutes. After the
product is used for a period of time, the suction will decrease with time. If
the suction becomes smaller, first check the product usage time.
If the suction is small at initial, please check whether the product is fully
charged.
Check if the filter is dirty.
If the above reason is excluded, please contact us support@holife.com.
2.The product is hot while using
Please power off first, and check if the dust container is full. if the dust
container is full, clean it according to the guide of emptying the dust con-
tainer.
Check if the filter screen and the foam filter element are blocked. If they
are blocked, please clean the filter according to the filter cleaning opera-
tion guide.
11