Horizon Global 118883 Instrucciones De Instalación página 4

Always wear SAFETY GLASSES
when installing wiring harness
4. Beginning on the driver's side and underneath the vehicle, route the
harness containing the yellow wire through the opening between the
vehicle bumper and body to the driver's side taillight located in the
bumper.
5. Locate the connector matching the end of the T-One® Connector.
Insert the T-One® Connector end containing the yellow wire in
between the vehicle and taillight connectors. All connector's surfaces
should be clean and free of dirt.
©2023 Horizon Global™ Corp
Installation Instructions
PART NUMBER: 118883
6. Underneath the vehicle on the passenger's side. Locate the black
7. Route harness containing the green wire to the passenger side. Route
If routing the wire thru a grommet and along the exterior of the vehicle, be
careful to avoid any hot pipes, heat shields, the fuel tank or any other
points that may pinch or break the wire.
environmental cover. Using a trim panel tool, remove the 3 plastic
clips, being carful to not damage them. Using a 10mm socket remove
the plastic nut and set cover aside
down and underneath the vehicle, up through the opening between
the vehicle bumper and body to the passenger's side taillight located in
the bumper.
Sheet 4 of 24 118883-NP 2/20/2023 Rev. A