PROBLEM
'7lower stops
3rass catcher
_ot filling
Hard to push
Mower Does Not
Stop when
Operator
Presence
Control
Bar is
Released
-CAUSE
o If high current light stays
on momedtarily
after
mower stops, load is too
much for m_wer.
If low power light stays
on, mower slows down,
lhen stops.
• Cutting height tO low
Lift on blade worn off.
Ca'tche_ not ve_tir_g air.
,, Grass is too high or wheel
height is leo low.
• Rear of lawn mower
housing or blade dragging
in grass.
• Grass catcher' too full,
• Handle heiglit position not
right for you,
Operator
presence control
bar is damaged.
. Start switch button sticks
or damaged.
CORRECTION
o Remove fuse and
turn mower all its side.
Make sure blade is free to
rotate. Also check mower
fol clogging.
o Batteries
may be low, near
the need of charging.
Recharge
batteries,
o Grass may be too heaw
for remaining
battery
capacity Try the following:
• Walk slower.
,, Reduce cutting width
o Raise mower cutting heigh'
- Raise cutting height
• Replace blade.
• Clean grass catcher.
,, Raise cutting height.
', Raise rear of lawn mower
housing one (1) setting
higher
o Empty grass catcher
. Adjust handle height to
suit
, Replace operator
presence
control bar.
• Replace start switch
button.
16