Descargar Imprimir esta página

Husqvarna 917.375351 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

Read these instructions
and this manual
in its entirety
before you attempt
to assemble
or
operate
your new lawn mower.
IMPORTANT:
This lawn mower
is shipped
WITHOUT
OIL OR GASOLINE
in the engine.
Your new lawn mower has been assembled
at the factory with the exception
of those parts
left unassembled
for shipping
purposes.
To ensure
safe and proper
operation
of your lawn
mower,
all parts and hardware
you assemble
must be tightened
securely.
Use the correct
tools as necessary
to ensure
proper tightness.
All parts such as nuts, washers,
bolts, etc.,
necessary
to complete
the assembly
have been placed
in the parts bag.
TO REMOVE
MOWER
FROM
CARTON
1.
Remove loose parts included with mower.
2.
Cut down two end corners
of carton
and lay end panel down flat.
3.
Remove
all packing
materials
except
padding
between
upper and lower
handle
and padding
holding
operator
presence
control
bar to upper handle.
4.
Roll lawn mower
out of carton
and
check carton
thoroughly
for additional
loose parts.
HOWTO SET UPYOUR
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold
handle
carefully
so
as not to pinch or damage
control
cables.
1.
Raise handles
until lower handle
sec-
tion locks into place in mowing
position.
2.
Remove
protective
padding,
raise up-
per handle
section
into place on lower
handle
and tighten
both handle
knobs.
3.
Remove
handle padding holding operator
presence
control
bar to upper handle.
Your lawn mower
handle
can be adjusted
for your mowing
comfort.
Refer to "AD-
JUST
HANDLE"
in the Service
and Adjust-
ments
section
of this manual.
Operator
MOWING
I
POSITION
control bar
TO ASSEMBLE
GRASS
CATCHER
1.
Put grass catcher
frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame
handle
is outside
of the bag top.
2.
Slip vinyl bindings
over frame.
NOTE:
If vinyl bindings
are too stiff, hold
them in warm water for a few minutes.
If
bag gets wet, let it dry before
using.
i
Vinyl
Frame
bindings
opening
TO INSTALL
ATTACHMENTS
Your lawn mower
was shipped
ready to be
used as a mulcher.
To convert
mower
to
bagging
or discharging,
see "TO CON-
VERT
MOWER"
in the Operation
section
of this manual.
UP
Upper
handle
Handle
knob
Lower handle

Publicidad

loading