Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Step 3: Installing the Faucet
3a. Take the faucet out of the packing box and fit the
faucet to the mounting hole on the sink, as shown
in diagram 1.
3b. Slide the rubber washer first, the metal gasket
second, and then the mounting nut over the hoses
onto the shank and hand tighten them firmly. Use a
cross screwdriver to thread the two screws, as
shown in diagram 2.
3c. Connect the hot & cold supply lines onto the
matching water valves and secure the connection
with an adjustable wrench, as shown in diagram 3.
3d. Connect the spray hose to the quick connection just
by a simple push .Install the counterweight on the
pull-down hose at the marked position (It should be
placed on the line), as shown in diagram 4.
3e. Turn on the hot and cold water valves then the
faucet. Run the water flow for 15 seconds to clean
up the lines and check for any leaks, as shown in
diagram 5.
3f. Turn off the faucet. Attach and secure the spray
head to the spray hose. Pull out or pull down the
spray head and get it return for a few times to
check if the pull-out hose is properly, as shown in
diagram 6.
3g. Test the water running, and make sure the faucet
sprayer changes between stream and spray
properly, as shown in diagram 6.
3h. After the installation completed, turn on the faucet
and run the water flow, check for any leaks again,
as shown in diagram 7.
3
1
3
5
6
2
4
6
7
Publicidad
