Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Table stop
1. Sharpen the bit by using
a small, smooth file,
following the original shape
of the bit. File the inside
edge of the spur, the sides
of the brad point, and
the cutting edge inwards
toward the flute of the bit.
See Figure 7.
Do not file the outside
edge of the spur as
this will affect the
diameter of the bit.
WIRING DIAGRAM
Magnetic switch
L
AC 230 v 50 Hz
N
Cutter
Pilot
Chisel
Hold chisel
in soft-faced
vise jaws
Figure 8
128º C
Auxiliary winding
2. Sharpen the chisel with a mortise chisel cutter with
the correct size pilot. (Pilot size will differ depending on
the size of your chisel). Two or three turns of the cutter
in a carpenter's brace chuck should be enough to
sharpen the chisel, as shown in Figure 8.
File
Figure 9
Capacitor
16uF
5
3. Use a small, triangular,
smooth file to relieve
the inner corners of
the chisel. See
Figure 9. Remove any
burrs from the outside
Chisel
of the chisel with
a fine oilstone.
Main winding
Publicidad
