Greencut Cargador CBT560L Manual De Instrucciones página 32

32
CHARGING A COOL BATTERY PACK
Only charge the 56V Li-Ion battery packs with this charger. Make sure the power supply is normal
household voltage, 100-240V / 50-60Hz, AC only. Make sure the battery pack. the battery pack
is secured in the charger before beginning operation.
1. Connect the charger to the power supply.
2. Place the battery pack in the charger, aligning theraised rib on the battery pack with
the groove in the charger.
3. Slide in the battery pack to be sure contacts on the battery pack engage properly
with contacts in the charger.
NOTE: After charging is complete, the green charger LED will remain on until the
battery pack is removed from the charger or charger is disconnected from the power
supply. The battery pack will become slightly warm to the touch while charging. This
is normal and does not indicate a problem. Do not place the charger and the battery
pack in an area of extreme hot or cold. They will work best at normal room
temperature.
NOTE: The charger and battery pack should be placed in a location where the
temperature is more than 10°C but less than 40°C.
4. When batteries become fully charged, unplug the charger from the power supply
and remove the battery pack.
BATTERY PROTECTION FEATURES
56V lithium-ion batteries are designed with features that protect the lithium-ion cells and
maximize battery life. If the tool stops during use, release the trigger to reset and resume
operation. If the tool still does not work, the battery needs to be recharged.
ATTENTION: If at any point during the charging process none of the LEDs are lit,
remove the battery pack from the charger to avoid damaging the product. Do not
insert another battery. Return the charger and battery to your nearest service centre
for service or replacement.