Craftsman 358.360121 Manual De Instrucciones página 15

1. Use thescrewdriver end ofthe
chain adjustment tool ( bartool) t o
move chain around g uide barto
ensure kinks do not exist. The
chain should rotate freely.
Bar
Chain Adjustment
Adjusting Tool
Chain Brake Screw (Bar Tool)
Nuts
2. Loosen chain brake nuts until they
are finger tight against the chain
brake,
3. Turn adjusting screw clockwise un-
til chain solidly contacts bottom of
guide bar rail.
__ Adjusting Screw
4. Using bar tool, roll chain around
guide bar to ensure all links are in
bar groove.
5. Lift up tip of guide bar to check for
sag. Release tip of guide bar, then
turn adjusting screw until sag does
not exist.
6. While lifting tip of guide bar, tighten
chain brake nuts securely with the
bar tool.
Chain Brake
_Nuts .
7. Use the screwdriver end of the bar
tool to move chain around guide bar.
8. If chain does not rotate, it is too
tight, Slightly loosen chain brake
nuts and loosen chain by turning
the adjusting screw counterclock-
wise. Retighten chain brake nuts,
9. If chain is too loose, it will sag be-
low the guide bar. DO NOT operate
the saw if the chain is loose.
zl, _
_WARNING: If the saw is operated
with a loose chain, the chain could
jump off the guide bar and result in se-
rious injury.
CHECK CHAIN SHARPNESS
A sharp chain makes wood chips, A
dull chain makes a sawdust powder
and cuts slowly. See CHAIN SHARP-
ENING in the SERVICE AND ADJUST-
MENTS section.
CHECK GUIDE BAR
Conditions which require guide bar
maintenance:
• Saw cuts to one side or at an angle.
• Saw has to be forced through the cut.
• Inadequate supply of oil to bar/chain.
Check the condition of guide bar each
time chain is sharpened. A worn guide
bar will damage the chain and make
cutting difficult.
After each use, ensure ON/STOP
switch is in the STOP position, then
clean all sawdust from the guide bar
and sprocket hole,
To maintain guide bar:
• Move ON/STOP switch to STOE
• Loosen and remove chain brake
nuts and chain brake. Remove bar
and chain from saw.
• Clean the oil holes and bar groove
after each 5 hours of operation.
ReGmuO_e Saw_t_
Oil Holes o" " _"_
• Burring of guide bar rails is a normal
process of rail wear. Remove these
burrs with a flat file,
• When rail top is uneven, use a flat file
to restore square edges and sides.
_h_ File RaiI Edges-_r] [1
a luSjrlS lu I
Worn Groove Correct Groove
Replace guide bar when the groove is
worn, the guide bar is bent or cracked,
or when excess heating or burring of
the rails occurs. If replacement is nec-
essary, use only the guide bar speci-
fied for your saw in the repair parts list
or on the decal located on the chain
saw.
CHECK FUEL MIXTURE LEVEL
• See FUELING ENGINE under the OP-
ERATION section.
15