Publicidad
Idiomas disponibles
Idiomas disponibles
SIDE HANDLE I NSTALLATION
items Needed:
114=20 x 1 1/2 Hex Screw (Qty: 8)
Handle (Qty: 2)
318" Wrench
Process:
oAttach (1) handle endcap using (2) screws.
Tighten with a wrench.
oAlign handle with notches in attached endcap,
hold in position.
oAlign notches in second handle endcap and attach using
(2) screws. Tighten with a wrench.
oTo remove, reverse the procedure.
o Handles are attached to both sides.
Screw
Handle
@
DIVIDER iNSTALLATION
items Needed:
10=24 x 5/16 Hex Screw (Qty: 8)
Dividers (Qty: 6)
5116" Wrench
Process:
o Decide which position and in which drawers they would
best serve your needs.
oThe dividers are cut to fit right to left in the drawers. If
you prefer to run them front to back, they may be
trimmed in length to do so.
o Position the dividers in the desired locations.
oThread screws through the bottom of the drawer and into
each divider. Tighten all the screws.
Dividers
Drawer
Figure 5
Figure 7
_Screw
CASTER INSTALLATION
(if required)
DRAWER LINER INSTALLATION
Items Needed:
5/16-18 x 1 Hex Screw (Qty: 16)
Caster Pack
112" Wrench
Process:
o Lay the cart down on its back. (Use packaging matedat
to protect the paint finish.)
o Mount both swivet casters on the same side of the cart
using (4) screws on each caster.
o Wrench tighten alt screws.
o Mount rigid casters to the opposite end of the cart in the
same manner.
o Return the unit to its upright position.
Items Needed:
Drawer Liner Rott
Scissors
Process:
o Remove the non-slip drawer liner from the rolt. The
drawer liner may be cut with scissors to fit each drawer
and around the drawer dividers, if necessary.
CHEST ATTACHMENT (if purchased)
Items Needed:
5/16-18 x 1 Hex Screw (Qty: 4) [included with chest]
5/16 Wrench
Process:
- Remove the wooden top from the cart.
o Remove the top two drawers of the cart (refer to the
drawer removal instructions).
o Lift the chest onto the cart. Line up the holes in the
bottom of the chest with the holes in the top d the cart.
oAttach the chest using (4) screws inserted from the
underside of the top of the cart. (See Figure 8)
o Wrench tighten all screws.
o Replace the drawer (refer to drawer
installation instructions).
- To remove, reverse procedure.
Figure 6
Publicidad
