Publicidad
Idiomas disponibles
Idiomas disponibles
2. Installation
The refrigeration systems, located at the back of the minibar, require proper ventilation for
the dissipation of the heat they generate. For this, air circulation is required, translated
into an air inlet below the minibar that runs through its entire depth until it reaches the
refrigerating system and an upper outlet that evacuates the heated air.
VERY IMPORTANT: You must install the minibar leaving the spaces indicated for it to
evacuate heat.
INSTALLATION TIPS MINIBARS
If the minibar is not installed respecting these spaces, the electronic circuits can be damaged,
its performance will also be reduced and its daily consumption will increase.
from
Hot air
60 mm
outlet
(110 mm Glow)
400 cm
2
Place your minibar on a surface that is strong enough to support the weight of the appliance
when it is full.
Do not expose the minibar to direct sunlight or sources of heat (radiator, heater...). Direct
sunlight can affect the surface finishes and heat sources can cause the appliance to increase
its consumption.
Avoid placing the minibar in damp areas.
from
60 mm
Plug the minibar into a dedicated, properly grounded power outlet. Any question on this
subject should be dealt with by a professional electrician.
The minibar should be placed in the coolest part of the room, away from heat-generating
appliances and sunlight.
Avoid overfilling the minibar. This will force the cooling system.
Minimize door openings and try not to keep the door open for too long and close it as soon
as possible.
FRONT
FLOOR
Hot air
outlet
400 cm
2
Entrance of
cold air
400 cm
2
from
120 mm
from
60 mm
FLOOR
from
60 mm
(110 mm Glow)
Hot air
outlet
400 cm
Entrance of
cold air
400 cm
2
FRONT
WALL
from
60 mm
2
(110 mm Glow)
Entrance of
cold air
400 cm
2
from
60 mm
(110 mm
Glow)
EN
9
Publicidad
