Publicidad
Idiomas disponibles
Idiomas disponibles
_RIVE CONTROL
Self-propelling
iscontrolled byholding
theoperator presence control bardown
tothehandle a ndpushing thedrive con-
trollever f orward u ntil i tclicks; then
release t helever.
Forward motion w ill s top when theoper-
ator presence control baris released.
Tostop forward m otion w ithout stopping
engine, release theoperator presence
control barslightly u ntil t hedrive control
disengages. Hold operator presence
control bardown tohandle t ocontinue
mowing w ithout self-propelling.
Tokeep drive control engaged when
turning c orners, push down onhandle
andliftfront w heels o ffground w hile
turning l awn mower.
Operator
presence
control bar
•
/",
Drive
k_\
.._\ _
\ \
_
control
To engage drive
Drive control
control
desengaged
3EFORE STARTING ENGINE
)IL
_'ourlawn mower is shipped without oil in
the engine.
Be sure mower is level and area around
oil fill is clean.
Remove engine oil cap w/dipstick and fill
to the full line on the dipstick.
Use 20 ozs. of oil. For type and grade of
oil to use, see "ENGINE" in Customer
Responsibilities section of this manual
Pour oil slowly. Do not over fill.
Check oil level before each use. Add oil if
needed. Fill to full line on dipstick.
To read proper level, tighten engine oil
cap each time.
° Reinstall engine oil cap and tighten.
Change the oil after every 25 hours of
operation or each season. You may need
to change the oil more often under dusty,
dirty conditions.
ADD GASOLINE
- Fill fuel tank. Use fresh, clean, regular
unleaded gasoline with a minimum of 87
octane. Do not mix oil with gasoline.
Purchase fuel in quantities that car'_ be
used within 30 days to assure fuel fresh-
ness.
IMPORTANT:
When operating in tempera-
tures below 32°F(0°C), use fresh, clean win-
ter grade gasoline to help insure good cold
weather starting.
WARNING:
Experience indicates that alco -_
ho! blended fuels (called gasohol or using
ethanol or methanol) can attract moisture
which leads to separation and formation of
acids during storage. Acidic gas can dam-
age the fuel system of an engine while in
storage. To avoid engine problems, the fuel
system should be emptied before storage of
30 days or longer. Drain the gas tank, start
the engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season. See Storage Instructions for
additional information.
Never use engine or
carburetor cleaner products in the fuel tank
or permanent damage may occur.
CAUTION:
Fill to bottom
of gas tank
filler neck.
Do not overfill.
Wipe off any
spilled oil or fuel.
Do not store, spill or
use gasoline
near an open flame.
Gasoline filler cap
Engine oil cap
TO START ENGINE
= To start a cold engine, push primer three
(3) times before trying to start. Use a firm
push. This step is not usually necessary
when starting an engine which has
already run for a few minutes.
• Hold operator presence control bar down
to the handle and pull starter handle
quickly. Do not allow starter rope to snap
back.
. To stop engine, release operator pres-
ence control bar.
Publicidad
