Descargar Imprimir esta página

Craftsman 917.299014 Manual De Instrucciones página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

5. With tine control "ON" (held down to
handle) push down on handle to raise
tines off the ground.
6. Slowly pull recoil starter handle while
observing
tines. Tines should rotate
forward.
7. If tines do not rotate, inner wire of con-
trol cable is too loose.
Loosen cable
clip and pull cable up to remove slack
and retighten clip.
8. Recheck in "ON" position and adjust if
necessary.
NOTE:
If "ON" position check required
adjustment,
recheck "OFF" position ad-
justment to insure tines do not rotate when
control is "OFF" (up).
Tine Control "OFF" Position
y
Tine Control "ON" Position
TO REPLACE
V-BELT
Replace V-belt if it has stretched consider-
ably or if it has cracks or frayed edges.
1. Belt guard must be removed to service
belt. See "TO REMOVE BELT GUARD"
in this section of manuaI.LT REMOVAL
2. Remove V-belt from transmission
pulley
first and then from engine pulley.
BELT REPLACEMENT
3. Install new V-belt to engine pulley first
then to transmission
pulley. Be sure belt
is positioned
on inside groove of both
pulleys, inside all belt guides and rests on
idler pulley.
4. See"TINE
OPERATION
CHECK" in this
section of manual.
5. Replace belt guard
Belt Guide
/
Engine
Pull
Cable Cli
Tine Control Cable
TO REMOVE
BELT GUARD
1. Remove screws from side of belt
guard.
2. Pul! belt guard out and away from unit.
3. Replace belt guard by reversing above
procedure.
Be sure slot in bottom of
belt guard is under head of tine shield
bolt and all nuts are tightened
securely.
Belt
Guard
Screw
Screw
V-Belt
Belt
Idler Pulley
Transmission
Pulley
ENGINE
Maintenance,
repair, or replacement
of
the emission control devices and systems,
which are being done at the customers
ex-
pense, may be performed by any non-road
engine repair establishment
or individual.
Warranty repairs must be performed
by an
authorized
engine manufacturer's
service
outlet.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact your nearest sears or
other qualified service center which has
the proper equipment and experience
to
make any necessary adjustments.
Screw
16

Publicidad

loading