Publicidad
Idiomas disponibles
Idiomas disponibles
short-circuited and an intense current will flow causing heat generation which may lead to
casing rupture or fire.
•
Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators and
other polymer components may be damaged, resulting in electrolyte leakage and/or internal
short-circuiting leading to heat generation causing rupture or fire. Moreover, do not dispose
of the batteries in fire, as explosion and/or intense burning may result.
•
Under extreme conditions, battery leakage may occur. When you notice liquid on the bat-
tery, proceed as follows:
– Carefully wipe the liquid off using a cloth. Avoid skin contact.
– In the event of skin or eye contact, follow the instructions below:
· Immediately rinse with water. Neutralise with a mild acid such as lemon juice or vinegar.
· In the event of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do not incin-
erate the battery.
7.2 Chargers (8)
•
Please only use the charger provided with the tool to charge the battery
•
Never attempt to charge non-rechargeable batteries.
•
Have defective cords replaced immediately.
•
Do not expose to water.
•
Do not open the charger.
•
Do not probe the charger.
•
The charger is intended for indoor use only.
8 FEATURES
8.1 Li-ion battery (9)
•
Advantages of Li-ion batteries :
•
Li-ion batteries have a higher capacity/weight ratio (more power for a lighter, more com-
pact, battery)
•
No memory effect (capacity loss after several charge/discharge cycles) like other type
batteries. (Ni-Cd, Ni-MeH, etc.)
•
Limited self-discharge. (also see chapter: Storage)
8.2 Keyless chuck (1)
A keyless chuck is included on your drill to allow for easy installation and removal of bits/acces-
sories. The chuck is divided into two parts. The rear is called the collar and the front is called
the body.
To open and close the keyless chuck, grasp and hold the collar of the chuck with one hand and
rotate the chuck body with your other hand. The arrows on the chuck indicate in which direction
to rotate the chuck body in order to GRIP (tighten) or release (unlock) the drill bit.
WARNING: Do not hold the chuck body with one hand and use the power of the drill
to tighten or loosen the juck jaws. The chuck body could slip and your hand could come
into contact with a rotating accessory. This could cause an accident resulting in person-
al injury.
27
Publicidad
