WolfPack DB5806 Manual De Instrucciones página 35

l) Any freely movable workpieces should be secured with a clamp or vice before starting work.
m) ALWAYS ensure that the lighting is adequate in the work area. Never remove your safety
goggles or glasses to improve your view — instead, increase the level of lighting or move
the light source so it specifically illuminates the work area correctly.
n) DO NOT operate the power tool near flammable materials. Be especially careful when cut-
ting wood and metal. Sparks from metal cutting are a common cause of wood dust fires.
o) Battery chargers are for indoors use only. Ensure that the power supply and charger are
protected against moisture at all times.
p) NEVER start the power tool while the blade or accessory is in contact with the workpiece,
and always allow the power tool to reach its full speed before making contact with the
workpiece. Use the variable speed control of the tool (if fitted) to start the tool at the correct
speed for the accessory or blade fitted.
q) DO NOT exert additional pressure on the body of the tool: allow the blade or accessory to
do the work. By not exerting additional pressure you will maintain a safer, stronger grip on
the power tool when it breaks through the material; this also reduces wear on the power tool
which will extend its service life. Additional pressure may also bend or twist the accessory
or blade, which may cause it to break and cause injury. If the power tool can be held with
one or two hands, hold it with two hands whenever possible.ALWAYS exercise caution when
handling this power tool.
r) Sawing, cutting and abrasive actions create heat. This may affect the workpiece and power
tool.
ALWAYS monitor the heat level, and in the event of excessive heat switch off the power tool
and allow it to cool before restarting work. Some power tools, depending on their design,
may be more quickly and effectively cooled by running at high speed without a load.
s) The power tool will draw in dust through the vents on its body. Excessive accumulation of
powdered metal may cause an electrical hazard and destroy the tool. ALWAYS ensure the
environment dust level is safe for the tool and ensure the vents are not blocked.
t) For mains-operated power tools, ensure the cable of the power tool is ALWAYS kept behind
the tool and never close to where the accessory or blade is operating.
u) DO NOT reach under the workpiece, rest the workpiece on your body, or hold the workpiece
while working on it, as contact with the blade or accessory protruding from the workpiece
can result in serious injury.
v) Anti-vibration gloves should be worn when operating power tools that produce large
amounts of vibration, especially during long-term use.
w) For power tools with a rotating mechanism and accessories, ensure the operator is not
wearing clothes or gloves with frayed threads, cords etc. that could be entangled in the
rotating mechanism, dragging the operator's hand into the rotating accessory causing injury.
ALWAYS wear tight-fitting work clothes and safety shoes. Remove jewellery and secure long
hair. NEVER wear fabric-based gloves that can produce strands of material when operating
this type of power tool.
x) DO NOT allow sanding sheets to wear away on the sanding pad. This will damage the sur-
face of the pad requiring replacement and may cause parts of the sanding sheet to fly off the
pad, causing operator injury.
y) DO NOT touch the moving sanding sheet.
z) Wire brush bristles are thrown by the brush even during ordinary operation.
DO NOT overstress the wires by applying an excessive load to the brush. The wire bristles
can easily penetrate light clothing and skin.
Note: The tool must ONLY be used for its intended purpose. Any use other than those men-
tioned in this manual will be considered a case of misuse. The operator, and not the man-
ufacturer, shall be liable for any damage or injury resulting from such cases of misuse. The
manufacturer shall not be liable for any modifications made to the tool, nor for any damage
resulting from such modifications.
35