Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC RECORDING
This section explains how to record from the tuner, CD player, or
external equipment.
.', ._
,,. ,_
4
'1
Preparation
Set the tape to the point where recording will start.
Use Type I (normal) and Type II (high/CrOz) tapes for recording.
1
2
3
4
5
Insert the tape to be recorded on into deck 2.
Insertthe tape with the side to be recordedon first facing
out from the unit
and the exposed side down.
A
I
4
Press the REV MODE button to select the reverse
mode.
To record on one side only, turn on =.
To record on both sides, turn on 1) or C=).
Press the DOLBY NR button to turn Dolby NR on
or off.
To record with DOLBY NR, turn on m NR.
To record without DOLBY NR, turn off UI NR.
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press the CD button and load the
disc(s).
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected source, press the VIDEO/
AUX button and play.
Press the
REC/REC
MUTE button
to start
recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press the
button.
To pause recording, press the 11 button. (Applicable when the
source is TUNER, VIDEO/AUX.)
To resume recording, press
again.
To start recording with the remote control
First press the
/0
REC/REC MUTE button, and then press
the + F button within 2 seconds.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables activation of the
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/AUX.)
1
2
Press the.
REC/REC MUTE button during recording or
while in recording pause mode.
~
on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode,
Press the II button to resume recording.
To insert a blank space of less than 4 seconds, press the
REC/REC MUTE button again while ~
is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the
REC/REC MUTE
button again. Each time the button is pressed, a 4-second blank
space is added.
To erase a recording
Make sure the microphone is not connected to this unit.
1
Insert the tape to be erased into deck 2 and press the TAPEI
DECK 112 button to display "TAPE 2.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing the REV MODE button.
4 Press the
REC/REC MUTE button to start the erasure.
13
ENGLISH
Publicidad
